This Code provides procedures for acceptance tests of steam turbines in nuclear and fossil-fired regenerative feedwater heater cycles.

The test procedures of this Report are intended for periodic steam turbine tests. May also be used for the analysis and supervision of relative performance throughout the life of the steam turbine.

This Code is used for testing steam turbines in combined cycles with/without supplementary firing. Also used in cogeneration applications. Applicable to condensing and noncondensing steam turbines.

This Code provides determination of performance of all sizes of hydraulic turbines and pump-turbines operating with water in either the turbine or pump mode.

This Code provides directions and rules for conduct and report of results of thermal performances tests for open cycle gas turbine power plants and gas turbine engines (gas turbines).

This Code provides the rules and procedures for the performance testing of hydraulic turbine speed governors. It is applicable to constant speed hydraulic turbines.

This Standard provides recommended practices for the prevention of water damage to steam turbines used in electrical power generation.

This publication includes all of the written replies issued between 1977 and June 1, 1983 to technical inquiries concerning interpretations of PTC 6-1976, PTC 6A-1964 and PTC 6S-1974.

This Code provides instructions on conducting tests of fuel fired steam generators, using H/C fuels. It can be used to determine performance characteristics such as efficiency, capacity and output.

The object of this Code is to establish procedures for conducting performance tests of Heat Recovery Steam Generators (HRSGs) used to recover gas turbine exhaust energy.

This Standard provides guidance and criteria for gas turbine systems used in marine applications and supplements the general gas turbine procurement standards presented in ASME’s B133 series

This Code provides for the testing of gas turbines with gaseous/liquid fuels and water/steam injection for emission control or power augmentation and may be used in combined-cycle and heat recovery

This Code provides procedures for acceptance tests of steam turbines in nuclear and fossil-fired regenerative feedwater heater cycles.

This standard provides guidance in the measurement of exhaust emissions of stationary gas turbines.

This Code provides the determination of performance of wind turbines.

This Standard covers both types of fuel for measurements and for procurement and compliance after installation.

This Standard provides a comprehensive, alphabetical list of technical terms pertinent to the B133 series of gas turbine procurement standards.

This Standard provides a review of shipping and installation items that should be considered in the preparation of gas turbine procurement specifications.

This appendix provides the calculation and correction of turbine test results, numerical examples, and guidelines for making these calculations and comparisons of procedures outlined in PTC 6.

This Standard provides a basis for the exchange of maintenance information between the gas turbine user and manufacturer.