This Code provides standards for conducting and reporting tests on reclosing and nonreclosing pressure relief devices in boilers, pressure vessels, and related piping equipment.

This Code provides test procedures to determine the thermodynamic performance of an axial and centrifugal compressors doing work on a gas of known or measurable properties under specified conditions.

This Code provides uniform test methods and procedures for the determination of the thermal performance and electrical output of heat-cycle electric power plants and cogeneration facilities.

This Code provides procedures for acceptance tests of steam turbines in nuclear and fossil-fired regenerative feedwater heater cycles.

This Code provides test procedures and definitions for the performance characterization of fuel cell power systems, which convert input fuel and oxidizer into output electrical and thermal energy.

This Document defines and describes the proper measurement of any flow required or recommended by any of the Performance Test Codes [PTC].

This document presents a summary discussion of temperature measurement as related to Performance Test Code work with particular emphasis on basic sources of error and means for coping with them.

The test procedures of this Report are intended for periodic steam turbine tests. May also be used for the analysis and supervision of relative performance throughout the life of the steam turbine.

This Code provides determination of performance of centrifugal pumps, including those of mixed flow and axial flow types utilizing liquids of Newtonian viscosity characteristics.

This Code provides definitions of terms, and values of physical constants and conversion values, that are used in ASME Performance Test Codes.

This document presents a summary discussion of pressure measurement as related to Performance Test Code work with particular emphasis on basic sources of error and means for coping with them.

This Code provides instructions for conducting performance tests of water-cooled steam surface condensers. This Code can be used for acceptance tests and routine performance evaluation of condensers.

This document includes guidelines for conducting performance monitoring of fossil-fueled steam plants and of balance-of-plant portion of nuclear power plants.

This Code provides determination of performance of all horizontal & vertical closed feedwater heaters except those with partial pass cooling zones.

This Code is used for testing steam turbines in combined cycles with/without supplementary firing. Also used in cogeneration applications. Applicable to condensing and noncondensing steam turbines.

This Code provides determination of performance of all sizes of hydraulic turbines and pump-turbines operating with water in either the turbine or pump mode.

This Code provides test methods for conducting thermal performance of wet mechanical draft, natural draft, wet-dry cooling towers, CCE (wet) coolers, and wet surface air-cooled steam condensers.

This Code provides test procedures to determine the performance of deaerators with regard to residual dissolved oxygen in the deaerated water and terminal temperature difference (TTD).

This document provides direction to code users in conducting tests (planning, preparation, implementation and reporting) and the expected uncertainties. It is considered part of the test.

This Code provides determination of performance of single-phase heat exchangers, for measuring fluid conditions, and for projecting performance parameters to reference conditions.